Franklin FPS-6A 100 LPM 240V Two-Wire Bore Pump – Complete Pump & Motor

The Franklin Electric FPS-6A is a complete high-capacity 4-inch submersible bore pump and motor assembly designed for applications requiring increased water volume from a bore.

Suitable for stock watering, tank filling, irrigation, domestic water supply and general rural water systems, the FPS-6A range has a nominal duty flow of 100 litres per minute. Three motor and stage configurations are available to suit different pumping heads, elevations and pressure requirements.

Available Variants

Increasing the number of stages increases the available pumping head. The correct model must be selected using the required flow and total dynamic head—not bore depth alone.

What Is Included

• Franklin FPS 4400 High Capacity pump end

• Franklin 240V single-phase two-wire motor

• Integrated stainless-steel wafer-style check valve

• Four-inch waterproof cable splice kit

• Three-year Franklin Electric warranty, subject to the applicable warranty terms

No separate external starter or motor control box is required for the two-wire motor.

Key Features

• Complete pump-and-motor assembly

• Nominal flow category: 100 litres per minute

• Nominal flow rating: 6 cubic metres per hour

• Motor sizes from 0.55kW to 1.1kW

• Five-stage, six-stage and nine-stage configurations

• Designed for suitable 4-inch or larger bore casing

• 50mm / 2-inch BSPF discharge

• Integrated stainless-steel wafer-style check valve

• Stainless-steel discharge head and motor bracket

• High-flow hydraulic staging designed to maximise output

• Impeller eye and hub seals to reduce internal leakage

• High-capacity upthrust protection

• Stainless-steel shaft, shell and shaft coupling

• Ceramic shaft sleeve and rubber discharge bearing

• Powered by a corrosion-resistant Franklin Electric submersible motor

• Maximum water temperature: 49°C

• 240V single-phase, 50Hz operation

Optional Add-Ons

• Submersible electrical cable in the required length and thickness

• Pumptec or Pumptec Plus motor protection

• Bore head or bore cap

• Stainless-steel safety cable and cable grips

• Water-level probes and matching protection relay

• Kelco float switch

• Pressure tank and pressure-control equipment

• Plasson pipe fittings and connection components

Electrical cable must be sized according to the selected motor, total cable distance, voltage drop and installation conditions. Cable selection and electrical installation must be confirmed by a licensed electrician.

Selecting the Correct Model

Total dynamic head must account for the pumping water level, bore drawdown, vertical elevation, required outlet pressure and friction loss through the pipework, valves and fittings.

The 100 LPM rating identifies the pump family and is not a guaranteed output under every installation condition. Actual performance will depend on the selected model and operating head.

Pipework should be sized carefully because reducing the 2-inch discharge or using undersized pipe over a long distance can create substantial friction loss and reduce the available flow.

Contact The Pump Shed Australia with your bore depth, pumping water level, elevation, pipe size, pipe length, required flow and required pressure if you need assistance selecting the appropriate model.

FPS-6A - 100 LPM Range

How to read the FPS-6A two-wire table: Flow is shown across the top in litres per minute (LPM). Each number in the table is Franklin's published total head in metres for the listed FPS-6A two-wire model at that flow. Only points inside the blue 65-126 LPM best-efficiency/warranty zone are shown; operation outside this zone is not covered by warranty.