Franklin FPS-2A 30 LPM 240V Two-Wire Bore Pump – Complete Pump & Motor

Franklin FPS-2A 30 LPM 240V Two-Wire Bore Pump – Complete Pump & Motor

The Franklin Electric FPS-2A is a complete four-inch submersible bore pump and motor assembly designed for applications requiring a higher water flow of approximately 30 litres per minute.

Suitable for domestic water supply, stock watering, tank filling, irrigation and general rural water systems, the FPS-2A range is available in four motor and stage configurations for different pumping heads and pressure requirements.

Available Variants

Increasing the number of stages increases the available pumping head. The correct model must be selected using the required flow and total dynamic head—not bore depth alone.

What Is Included

• Franklin FPS 4400 Tri-Seal pump end

• Franklin 240V single-phase two-wire motor

• Built-in removable spring-loaded check valve

• Four-inch waterproof cable splice kit

• Three-year Franklin Electric warranty, subject to the applicable warranty terms

No separate external starter or motor control box is required for the two-wire motor.

Key Features

• Complete pump-and-motor assembly

• Nominal flow category: 30 litres per minute

• Motor sizes from 0.37kW to 1.1kW

• Six to 18-stage configurations

• Efficient operating range of approximately 24–41 litres per minute

• Fits standard four-inch bore casing

• Maximum diameter with cable guard: approximately 99.1mm

• 32mm / 1¼-inch BSPP female discharge

• Tri-Seal floating-stage hydraulic design

• Abrasion-resistant impellers and diffusers

• Corrosion-resistant Franklin Electric submersible motor

• Ceramic shaft sleeve and rubber discharge bearing

• Maximum water temperature: 49°C

• 240V single-phase, 50Hz operation

Optional Add-Ons

• Submersible electrical cable in the required length and thickness

• Pumptec or Pumptec Plus motor protection

• Bore head or bore cap

• Stainless-steel safety cable and cable grips

• Water-level probes and matching protection relay

• Kelco float switch

• Pressure tank and pressure-control equipment

• Plasson pipe fittings and connection components

Electrical cable must be sized according to the selected motor, total cable distance, voltage drop and installation conditions. Cable selection and electrical installation must be confirmed by a licensed electrician.

Selecting the Correct Model

Total dynamic head must account for the pumping water level, bore drawdown, vertical elevation, required outlet pressure and friction loss through the pipework and fittings.

The 30 LPM rating identifies the pump family and is not a guaranteed output under every installation condition. Actual performance will depend on the selected model and operating head.

Contact The Pump Shed Australia with your bore depth, pumping water level, elevation, pipe size, pipe length, required flow and required pressure if you need assistance selecting the appropriate model.

FPS-2A - 30 LPM Range

How to read the FPS-2A two-wire table: Flow is shown across the top in litres per minute (LPM). Each number in the table is the approximate total head in metres that the listed FPS-2A two-wire model can produce at that flow. Only points inside the blue 24-41 LPM best-efficiency/warranty zone are shown; operation outside this zone is not covered by warranty.