Franklin FPS-12A 200 LPM 240V Three-Wire Bore Pump – Complete Pump, Motor & Starter Box

Franklin FPS-12A 200 LPM 240V Three-Wire Bore Pump – Complete Pump, Motor & Starter Box

The Franklin Electric FPS-12A is a complete high-capacity 4-inch submersible bore pump package designed for applications requiring substantial water flow across moderate to high pumping heads.

Suitable for large-scale irrigation, stock watering, rapid tank filling, water transfer and commercial or rural water systems, the FPS-12A range has a nominal duty flow of 200 litres per minute. Three motor and stage configurations are available to suit different pumping levels, elevations and pressure requirements.

Available Variants

Increasing the number of stages increases the available pumping head. Select the correct model using the required flow and total dynamic head—not bore depth alone.

What Is Included

• Franklin FPS 4400 High Capacity pump end

• Franklin 240V single-phase three-wire submersible motor

• Matched Franklin capacitor starter box

• Integrated stainless-steel wafer-style check valve

• Four-inch waterproof cable splice kit

• Three-year Franklin Electric warranty, subject to the applicable warranty terms

The included starter box contains the starting components required by the three-wire motor. It does not replace suitable dry-run, overload, low-water-level or surge protection.

Key Features

• Complete pump, motor and starter-box package

• Nominal flow category: 200 litres per minute

• Motor sizes from 1.5kW to 3.7kW

• Ten to 23-stage configurations

• Suitable for standard 4-inch bore casing

• 50mm / 2-inch BSP female discharge

• Stainless-steel discharge head and motor bracket

• High-flow impellers and hydraulic stages

• High-capacity up-thrust protection for starting and operation

• Ceramic shaft sleeve and rubber discharge bearing

• Stainless-steel pump shaft, shell and shaft coupling

• Corrosion-resistant Franklin Electric submersible motor

• 230–240V single-phase, 50Hz operation

Optional Add-Ons

• Submersible electrical cable in the required length and thickness

• Compatible dry-run and motor-protection equipment

• Bore head or bore cap

• Stainless-steel safety cable and cable grips

• Water-level probes and matching protection relay

• Kelco float switch

• Pressure tank and pressure-control equipment

• 50mm Plasson pipe fittings and connection components

Electrical cable must be sized according to the selected motor, total cable distance, voltage drop and installation conditions. Cable selection and electrical installation must be confirmed by a licensed electrician.

Selecting the Correct Model

Total dynamic head must account for the pumping water level, bore drawdown, vertical elevation, required outlet pressure and friction losses through the pipework, valves and fittings.

The 200 LPM rating identifies the pump family and is not a guaranteed output under every installation condition. Actual performance depends on the selected model and operating head.

Contact The Pump Shed Australia with your bore depth, pumping water level, elevation, pipe size, pipe length, required flow and required pressure if you need assistance selecting the appropriate model.

FPS-12A - 200 LPM Range

How to read the FPS-12A three-wire table: Flow is shown across the top in litres per minute (LPM). Each number in the table is Franklin's published total head in metres for the listed FPS-12A three-wire model at that flow. Only points inside the blue 110-210 LPM best-efficiency/warranty zone are shown; operation outside this zone is not covered by warranty.