3-Core-and-Earth Rubber Submersible Bore Pump Electrical Cable

Heavy-duty 3-core-and-earth rubber electrical cable suitable for connecting compatible submersible bore-pump motors to their surface starter, controller or electrical supply.

The flexible rubber outer sheath helps protect the internal conductors in wet, outdoor and demanding bore-pump installations. Cable is supplied in cut lengths, allowing the conductor size and length to be selected for the individual pump installation.

This is a third-party compatible installation accessory and is not manufactured or branded by Franklin Electric.

Compatible pumps and applications

Suitable for correctly matched:

• Franklin FPS 240V three-wire single-phase bore-pump motors
• Franklin FPS 415V three-phase bore-pump motors
• Compatible three-wire single-phase and three-phase submersible motors
• Bore, irrigation, stock-water and rural pumping installations

Available cable sizes

• 4mm² 3-core-and-earth rubber cable
• 6mm² 3-core-and-earth rubber cable
• 10mm² 3-core-and-earth rubber cable
• 16mm² 3-core-and-earth rubber cable

Available in 10-metre increments from 10 metres through to 200 metres.

What is included

• Selected length of 3-core-and-earth rubber electrical cable

What is not included

• Bore pump or motor
• Starter box, control panel or motor protection
• Waterproof cable splice kit
• Cable joining or termination service
• Electrical installation
• Stainless-steel safety cable
• Cable ties or installation hardware

Installation and selection warning

The cable size must be confirmed by a licensed electrician using the motor voltage, phase, rated current, starting current, total cable length, supply conditions and permitted voltage drop.

Do not select cable size from bore depth alone. Undersized cable can cause excessive voltage drop, starting problems, nuisance tripping, overheating and permanent motor damage.

Confirm that the cable construction and submersion rating are suitable for the complete installation. Any submerged connection must be completed using a correctly sized waterproof splice kit. All electrical installation, connection and testing must be completed by a licensed electrician in accordance with applicable Australian requirements.