Disclaimers For All Products.

Disclaimer

The Pump Shed Australia provides product information, specifications, sizing recommendations, flow rate data and technical advice as a general guide only. Information supplied on this website, by email, over the phone or through other communications does not take into account your specific site conditions, installation requirements or intended application.

Pump sizing recommendations are based solely on the information provided by the customer. The accuracy of any pump selection, sizing advice or system recommendation is dependent upon the completeness and accuracy of the information supplied, including but not limited to flow requirements, pipe size, pipe length, elevation, water source details, pressure requirements and operating conditions. The Pump Shed Australia accepts no responsibility for pump performance or suitability where incorrect, incomplete or inaccurate information has been provided.

For bore pump applications, The Pump Shed Australia strongly recommends that all boreholes be professionally tested for a minimum of 24 hours to determine sustainable yield, drawdown characteristics, recovery rates and overall bore performance prior to pump selection and installation. Pump recommendations provided without a bore test are based on assumptions and may not accurately reflect actual bore conditions.

The Pump Shed Australia recommends the use of appropriate pump protection equipment, including but not limited to dry-run protection, low water level protection, motor protection, surge protection, pressure protection and other equipment recommended by the manufacturer. While these products may be recommended, customers are not required to purchase them. However, failure to install appropriate protection equipment may result in equipment damage, reduced service life or warranty exclusions in accordance with the manufacturer's warranty terms and conditions.

All pumps, motors, controllers, protection equipment, electrical components and associated products should be installed, commissioned and serviced by appropriately licensed and qualified professionals in accordance with manufacturer instructions, Australian Standards and applicable regulations. Improper installation, misuse, modification, inadequate protection, incorrect operation or failure to follow manufacturer recommendations may void product warranties.

Product suitability may vary depending on factors including, but not limited to, water quality, pressure, flow rate, pipe size, pipe length, elevation, friction losses, system design, power supply, operating conditions, installation methods and maintenance practices.

Customers are responsible for ensuring products are suitable for their intended use and should seek professional advice where necessary. The Pump Shed Australia recommends that all pumps, fittings, valves, pipework, filtration equipment, irrigation products, float valves, consumables and associated components be installed in accordance with manufacturer recommendations, relevant Australian Standards and applicable regulations.

Product specifications, dimensions, flow rates, pressure ratings, performance curves and technical data are supplied by manufacturers and are subject to change without notice. Actual performance may vary depending on installation and operating conditions.

To the maximum extent permitted by law, The Pump Shed Australia accepts no responsibility for any loss, damage, injury, downtime, consequential loss, loss of production or costs arising from the use of, or reliance upon, information, recommendations or advice provided by The Pump Shed Australia or contained on this website.

All information is provided in good faith and is intended as a general guide only. Customers should independently verify all information and satisfy themselves that products are suitable for their specific application prior to purchase and installation.